VOLTAGE TESTER 70-220V - YT-28630

TECHNICAL DATA: Brand: Yato Symbol: YT-28630 Series: GRA Application: electric Power supply: battery Battery type: 3x1.5V LR41 Length: 145 mm Voltage: 12-250 V dc Display type: LCD Tip: Flat Flat tip size: 2.9 mm Voltage - inductive method: 12-250 V ac Continuity test: YES Diode indicators: yes Frequency of measured voltage: 50-500 Hz Voltage - contact method: 12-250 V ac Ground Test: Yes The YT-28630 Electrical Indicator with LCD display allows you to determine the presence of AC and DC electrical voltage, detect AC voltage using the inductive method, and perform a wire continuity test. The presence of voltage is indicated by a reading on the LCD display and a lit LED. INDICATOR FUNCTIONS detection of AC and DC voltage using the contact method: 12 - 250V detection of AC voltage using the inductive method wire continuity test CONTACT METHOD Place the tip on the live circuit. The display will show the voltage values, and the LED will light up to indicate electric current flowing through the element. The indicator will show the highest voltage range for the tested circuit and all lower ranges. For example, when measuring voltage from a 230V household socket, the display will show [12, 36, 55, 110, 220], which means voltage above 220V. The display indicates the correct voltage ranges for the AC waveform when the "Contact Test" field is held down. For DC waveforms, the correct ranges are displayed when the "Induction Test" field is held down. INDUCTIVE METHOD This method allows you to detect AC voltage in an insulated wire. To do this, place your finger on the "Induction Test" field and bring the tip close to the insulated wire. The presence of a lightning bolt symbol on the LCD indicates the presence of voltage. This method also allows for "non-contact" detection of a break in a live electrical wire. At the break point, the tester will stop signaling the presence of voltage. CHECKING WIRE CONTINUITY Check wire continuity by touching the tester tip to one end of the wire, then, while holding the "Contact Test" field, grasp the other end of the wire. The LED will illuminate to indicate continuity of the tested wire. It is prohibited to use this method to check the continuity of wires that are live or in an electrical circuit. **