5V ZVS Induction Heating Module Driver Heater

Description:

- 1. no tap this mini board ZVS finished , without the heating coil, ignition coil, cooling fans, etc.

- 2. this kit requires a certain ability and relevant knowledge. If even the iron will not use, the power supply will not be positive and negative points, it is recommended not to shoot. Took out of the question, the seller does not undertake any responsibility!

- 3. the maximum power of 120W (12V induction heating). Push the ignition coil 12V, when the primary 5 + 5 turns, 30W or so.

- 4. the input voltage DC 5V ~ 12V (5V voltage exceeds 12V or lower than the seller is not guaranteed to work properly, the input voltage is not within this range, a problem the seller is not liable!)

- 5.Make sure that all components soldered correctly, the power line is not reversed negative, then power!

Specification:

- Input voltage: 5v-12v

- Module dimensions(L*W*H): 5.5 x 4 x 2 cm/ 2.17x1.57x0.79 inch

- Coil size

- Length:7.5cm/ 2.95 inch

- Width: 2.8cm/ 1.10 inch

Package Includes: 1 Piece induction heating power supply module 1 Piece coil

Note: The reasons why the indicator light is off may be: 1. The wire is not connected properly and the power supply is not energized. 2. The board has component damage. When the indicator light is dark, the power supply should be insufficient, and a larger power supply should be replaced. Non-tap is suitable for induction heating. The heating coil can be soldered to the PCB.