Feature:
1. Wide Application: The tankless water heater is small in size, with quick heating and convenient to install, suitable for installation in kitchen, toilet, shower, public toilet, etc.
2. Suitable: The water heater is suitable for daily washing, such as hands, dishes, face and bathing, temperature range between 30 to 55 degree centigrade, it can be controlled by remote controller or its touch screen button.
3. Quick Heating: The household water heater can supply constant hot water at 30 degree centigrade or higher, no need to wait for preheating or the temperature rise and fall.
4. Convenient: The ABS water heater is equipped with digital display and touch the control panel so the temperature setting is easy, time and labor saving by intelligent control.
5. Multi Protection: The intelligent water heater possesses multiple protection, has been strictly tested, safe and efficient, designed to run water and electricity separately to avoid leakage or scale accumulation.
Specification:
Item Type: Tankless Water Heater
Material: ABS, Copper, Aluminum Alloy, Reinforced Glass
Weight: Approx. 1913g/4.22lb
Size: Approx. 21x15x5.5cm/8.27x5.91x2.17in
Heating Body: Aluminum Die Casting
Voltage: 110V (US Plug)
Power: 3000W
Frequency: 50 to 60 HZ
Wiring: 2.08square meters
Waterproof Grade: IPX4
Remote Control Power Supply: 2 AAA Battery (Not Included)
Temperature Range: 30 Degree Centigrade to 55 Degree Centigrade.
Package List:
1 x Tankless Water Heater4 x Screw 4 x Expansion Tube 1 x Use Manual 1 x Remote Controller 1 x Remote Controller Bracket 1 x Measuring Scale
Note:
1. The water heater first run water and then run electricity, applicable water pressure is 0.04 to 0.6MPA; 2. The power switch should be installed below it, not touch the cabinet; 3. It should be installed in the place where the indoor ambient temperature is above 0 degree centigrade, the pipeline should be centrally arranged, the hot water outlet should not be too far away from the hot water using electricityCommon faults and handling methods:1. Check whether the power supply is normally energized. When power on, the display screen will light up to show the temperature, no power will not light.2. Under normal power condition, water flow is turned on, press the middle switch, it will start heating, and the water heater will display: Set temperature, water flow, outlet temperature.3. If the temperature does not rise, there are two possibilities: one is that the temperature control switch (overheat protection switch) is faulty, which can be recovered by pressing the temperature switch; the other is that the heating tube is faulty, which can be replaced by the heat pipe.4. If the display shows no heating, display shows temperature, dose not show water flow and the set temperature, means water flow without water heater, or water pressure is too low, or install the wrong direction. Pay attention to water entrance and outlet to be installed correctly. But if the water pressure is reached, water will also not heating, then check the water heater inlet volute , it is possible that there is dirt stuck volute, The water heater will not start.5. It is recommended that the length of water outlet pipe should not exceed 3 meters. If the length exceeds 3 meters, there may be water pressure difference due to the length of water pipe. (If the water tower is used in rural areas, it is required that the height of the water tower is higher than 10 meters)
