FOR New Triton L200 LC2T GLS GSR (February 2024~) Triton

• ▶Special Vehicle Adaptability - Exactly matches the design of Triton L200 LC2T GLS GSR (from February 2024) series models, ensuring seamless compatibility of installation fit and door structure. triton

• ▶Reinforced carbon fiber material - Adopts lightweight and high strength carbon fiber composite material, combining wear resistance and impact resistance with premium texture. triton

• ▶Multiple protection functions - Integrates triple protection of anti-scratch, anti-scratch and anti-wear, effectively resisting damage caused by daily scratches on the door and door sill area.

• ▶MATTE BLACK SPORTS AESTHETICS - The black carbon fiber texture surface matches with the matte treatment, enhancing the sport style of the car body and enhancing the sense of luxury.

• ▶4-Piece Complete Coverage - Includes protective component sets (4 pieces/set) for front and rear doors, door sills, providing integrated protection of critical areas throughout the door.

Product description Precautions and methods when installing 1. Please prepare auxiliary tools such as a soft rubber hammer, dry towel, and ruler in advance to avoid inaccurate installation due to Triton bare hand work. 2. Gently place the protective cover on the corresponding door or sill and check whether the edges are aligned. If necessary, use a ruler to measure left-right symmetry and mark reference lines. 3. Peel off the adhesive protective film on the back of the protective cover, apply the adhesion promoter evenly (if you need to increase adhesion), and leave for 30 seconds until the adhesive surface becomes slightly sticky. 4. Align the marking lines and press firmly from the center of the protective cover towards the perimeter to ensure the adhesive side fits perfectly. Gently tap the edges with a rubber mallet to eliminate any air bubbles or gaps. 5. To ensure the colloid is fully cured, please do not wash the car, expose it to sunlight, or open and close the car door frequently within 48 hours after installation. Make sure all parts are solid and not warped.