Temperature Humidity Transmitter Probe RS485 IP67 Waterproof Sensor Probe 150cm DC5?24V

Feature: 1. Chip: Temperature humidity transmitter probe adopts for 3X series of chips, which makes the transmitter probe low power consumption and high accuracy specifications. With fully calibrated, RS485 communication interface output. 2. IP67 Waterproof: Temperature humidity transmitter probe has IP67 waterproof, high temperature and low temperature resistance, etc. 3. High Reliability and Stability: The temperature and humidity sensor probe has high reliability and stability. Operating voltage is DC5 to 24V. 4. Light and Compact: Temperature and humidity sensor probe is small and light, easy to carry and install, does not take up too much space. 5. Wide Usage: Temperature and humidity transmitter probe is suitable for food temperature measurement, smart home appliances, agriculture, industry, etc. Specification: Item Type: Temperature Humidity Sensor Probe Housing: 304 Stainless Steel, Plastic Waterproof: IP67 Waterproof Working Current: Less Than 10mA Humidity Accuracy: +2percent RH Temperature Accuracy: +0.2 celsius Working Voltage: DC524V Temperature Measurement Range: 20 celsius 100 celsius Humidity Measurement Range: 0100percent RH Output Mode: RS485 Output Working Conditions: 40 celsius 125 celsius , 099percent RH Storage Conditions: 20 celsius 80 celsius , 095percent RH Line Length: Approx. 150cm 59in Caution Air relative humidity is a function of temperature, air temperature has a great impact on relative humidity, acids, bases, salts and other compounds have a significant impact on the physical properties of water vapors, the following matters should be noted when using: 1. The temperature and humidity sensor should be installed in a relatively stable temperature, the most representative of the measured ambient temperature and humidity. 2. Avoid installation in places with drastic temperature changes. 3. Avoid installation in places where the air flows intensely. 4. Avoid installation in dead ends where air does not flowing. 5. Avoid using in the environment with salt spray. 6. Avoid using in corrosive gas environment. Operating conditions The sensor performs normally within the recommended operating range, refer to the figure. Long term exposure to conditions outside the normal range, especially at humidity levels greater than 80percent , may cause temporary drift of the signal (+3percent RH after 60 hours). Upon return to normal operating conditions, the sensor will slowly self revert to the corrected state. Prolonged use under abnormal conditions will accelerate the aging of the product.. Package List: 1 x Temperature Humidity Transmitter Probe Note: 1. Temperature humidity transmitter probe is not an ordinary electronic component and needs to be carefully protected. Users must take this seriously.2. Prolonged exposure to high concentrations of chemical odors can cause sensor readings to drift.Chip: Temperature humidity transmitter probe adopts for 3X series of chips, which makes the transmitter probe low power consumption and high accuracy specifications. With fully calibrated, RS485 communication interface output. IP67 Waterproof: Temperature humidity transmitter probe has IP67 waterproof, high temperature and low temperature resistance, etc. High Reliability and Stability: The temperature and humidity sensor probe has high reliability and stability. Operating voltage is DC5 to 24V. Light and Compact: Temperature and humidity sensor probe is small and light, easy to carry and install, does not take up too much space. Wide Usage: Temperature and humidity transmitter probe is suitable for food temperature measurement, smart home appliances, agriculture, industry, etc.