WirusWin Fender Eliminator Kit for FORZA (MF13)

Product Introduction

This is a fender eliminator kit for the MF13 Forza. *Compatible with vehicle model: 2BK-MF13. Simply remove the stock fender and bolt it on for a worry-free installation. You can reuse the factory license plate light for peace of mind. The fender eliminator exposes the rear tire, creating a wild look. This is a classic customization for big scooters. Made from durable, corrosion-resistant SUS304 stainless steel with a buffed finish. An essential accessory for adding a touch of style! Highly recommended for those looking for an easy customization or to get started on your customization journey. Includes WirusWin stickers and WirusWin plates.

・ ・ ・ Notes ・ ・ ・ The factory fender eliminator kit is designed to create a clean, streamlined rear end by removing the long factory fenders (mud flaps). Additionally, to reduce air resistance during rear maintenance and racing, manufacturers' license plate holders are designed with the ability to adjust their angle.

However, the Road Traffic Act requires the installation of reflectors and requires license plates to be mounted at an angle of approximately 45 degrees or less (an angle at which the license plate can be seen from behind).

While manufacturers' license plate holders are adjustable, using them at angles exceeding the safety standards (i.e., angles that prevent accurate visual confirmation) is prohibited by law on public roads and other roads where the Road Traffic Act must be observed. Please refrain from doing so.

Safety Warning

Please be sure to check your vehicle model before ordering. Please note that we cannot accept cancellations for products that are not defective.

Compatible Models: FORZA (MF13) Compatible with: Honda [HONDA]: Engine Displacement 126cc-250cc: FORZA [Forza MF13]

Installs with no modifications required, simply remove the stock fender and bolt it on. You can use the factory license plate light for peace of mind. The rear tire is exposed by eliminating the fender, creating a wild look. This is a classic customization for big scooters. The material is SUS304 stainless steel with a buffed finish, which is highly durable and corrosion-resistant. It is an essential item for adding a touch of dress-up! It is especially recommended for those who want to easily customize their bike, or as a starting point for customization. *Please see the product description for important notes.