3-in-1 Micro Carving Skin Grinding Machine Professional Microdermabrasion Face Cleaner Desktop Microsculpture Skin Grinder

Joom: Dette produktet er et medisinsk utstyr som kun må brukes som tiltenkt og i samsvar med bruksanvisningen. Dette utstyret erstatter ikke profesjonell medisinsk rådgivning, diagnose eller behandling. Rådfør deg med kvalifisert helsepersonell før bruk hvis du er i tvil. Selgeren/distributøren er ikke ansvarlig for skader som følger av feilbruk, uautorisert modifikasjon eller bruk utover angitte indikasjoner.

-----

Specifications:

Product Category: Microdermabrasion Machine

Power: 2A

Voltage: 220V/60HZ

Application: Cosmetic Salon

Package Size : 25.50*12.00*18.50cm

Functions

1. Abrade or rub off the top skin layer by using sterile diamond heads.

2. Remove dirt, skin debris, imperfections, blemishes, wrinkles and unw

3. Helps replenish natural nutrients, restore cell activity and promote skin health.

Operating instruction

1. Push in the movable ring of copper nozzle at the hand piece, and pull out the 8x5 size vacuum hose. Then push in the black plastic ring on the vacuum hose.

2. Put a drop of cream or milk lotion on the vacuum hose nozzle, push in the moveable ring and insert in the vacuum hose to the limit.

3. Insert a cotton swab into the Diamond Head, then tight up the Diamond Head on the hand piece. Remove the cotton swab after every treatment.

4. Turn on the power switch.

5. Adjust the Vacuum intensity by Vacuum Regulator according to the reference table, the intensity displays on vacuum gauge and check for comfort.

6. Use the incline area of Hand piece to contact with the skin surface. Proceed with a slow sliding motion. Do not place the hand piece at one spot for too long, doing this will cause harm to the skin.

7. Adjust the crystal flow rate by Vacuum Regulator slowly from minimum to maximum. For common use, don't set the flow rate to maximum unless it is of necessity. This is better comfort intensity.

8. Gently stretch the skin with thumb and finger, and glide the Hand-piece 2 to 3 times over the area being treated.

Then cross again in different directions to prevent streaking lines as in the reference picture. Brush strokes or prevent streaking lines as in the reference picture. Brush strokes or polishing motions may be used in different sites.

9. After treatment, brush off all remaining dead skin with a soft brush and rinse with damp sponges or damp cool towel.

10. Allow skin to dry then apply desired skin product.

11. To clean the Diamond Head, use toothbrush or cotton swab damped with a little alcohol to wipe off the dirty impurity, and then use UV light or high temperature for sterilization.

Package Included:

1 x Microdermabrasion Machine

1 x User Manual

Note:

-Due to different producing batches, product details might be a little different. If you minding the difference, please buy it carefully.

-Due to the different display and different light, the picture may not reflect the actual color of the item. Thanks for your understanding.